Man nehme einen Breitbänder, ein Gehäuse und lasse im Grunde alles weitere weg. Heraus kommt wahrscheinlich ein Lautsprecher, der nicht besonders gut klingt. Es sei denn, man weiß, was man tut.
>> Mehr erfahren>> Alle anzeigen
Audio System hat seiner modernsten DSP-Endstufengeneration eine kleine Überarbeitung gegönnt, die in der Praxis einen großen Unterschied macht.
>> Mehr erfahren>> Alle anzeigenKategorie: Car Hifi Endstufe Multikanal
Ausstattungsliste: Polk Audio PA D5000.5
| Electrical | |
| Total Frequency Response | 20Hz-20kHz |
| Signal-to-noise (Referenced to rated power) | 105 dBA |
| Remote Gain | yes, for bass |
| Distortion at Rated Power | <0.1 % |
| Minimum Impedance Bridged | 4 ohms |
| Minimum Impedance Not Bridged | 2 ohms |
| Protection Circuitry | Thermal, DC offset, reverse DC voltage and short circuit; fuses: two 40 Amp ATC |
| Subsonic Filter | yes |
| High Pass Filter | |
| Filter Slope | 12dB/octave |
| Filter Frequency | 40Hz-400Hz(front)/40Hz-4kHz(rear) |
| Low Pass Filter | |
| Filter Frequency | 80Hz-4kHz(front) |
| Max Sensitivity | 200mV-6V dB |
| Cabinet Dimensions | |
| Height | 1 13/16" (4.60cm) |
| Width | 13 5/16" (33.81cm) |
| Depth | 6 3/4" (17.14cm) |
| Product Weight (each) | 6.750 lbs. pounds |
| Dimensions With Panels | |
| Height | 1 13/16" (4.60cm) |
| Width | 13 5/16" (33.81cm) |
| Depth | 6 3/4" (17.14cm) |
| Amplifier Specs | |
| Power Specs | 100W x 4, 400W x 1 RMS @ 2 ohms; 70W x 4, 200W x 1 RMS @ 4 ohms; 200W x 2 RMS bridged @ 4 ohms; 500W x 1 RMS @ 1 ohm (sub) |
| Channels | 5 |
| Channel Notes | Bridgeable Class D MOSFET |
| 12V & Ground Cable Gauge | 4AWG |
| Amplifier Power Specs | |
| RMS Power at 14.4V | |
| Watts per channel NOT bridged @ 1 kHz | |
| 4 ohms | 70 x 4 watts |
| 2 ohms | 100 x 4 watts |
| Watts per channel bridged | |
| 4 ohms | 200 x 2 watts |



